LCD menus were changed to "slim mode" to save memory space.Due memory size limitations, the power resume function was disabled as well as the arc support.All changes from the original Marlin config file were marked with the comment tag "Customized DBP".Baby steps enabled and configured for the stepper driver "Magic Numbers".M503 enabled (reports all printer settings).Run and toggle the bed level and BLTouch tools from LCD menus.Ultra-precise bilinerar bed leveling algorithm with 25 probing points, 3 slow probes per point (takes about 10 minutes to complete).Custom menu with maintenance mode, emergency mode and full auto bed leveling sequence (warmup, wait, home, level and then save settings).Does not reset the bed level settings after the G28 (Home) command.Source code modified to prevent releasing the BLTouch sensor during "beep" events triggered by LCD menus.Installs from the PlatformIO IDE that runs in several operating systems.
Compatible with BLTouch versions from 1.0 up to 3.x BLTouch original/generic versions enabled by default.The maximum amount of Marlin features that I was able to fit in the small 128KB memory.Official "vanilla "Marlin firmware with all hardware settings from Creality latest official firmware.It was downloaded and installed more than 10000 times and I believe most of the users will find no problems with it. Anyway, if you want to try this you can be sure I did the best I could to configure it properly and fit the maximum amount of features possible. Marlin 2.x is aimed to a new generation of boards using 32-bit processors, the built in libraries are bigger and there is less space left for features. The most stable and feature rich version of the firmware for this architecture is the 1.1.9 that I made available in another article. Please note that this is not the version I recommend for 8-bit boards like the one used in the Ender 3. The standard configuration file from Marlin distribution was carefully reviewed to include the latest Ender 3 specific settings from the official Creality firmware and from Antclabs. This is the vanilla version of Marlin Firmware 2.x pre-configured for Creality Ender 3 printers with original or generic BL Touch sensors.
0 kommentar(er)
